ASI 9468-25 | ASI Profile Collection Recess Mounted Dual Sanitary Napkin & Tampon Dispenser
American Specialty Profile Collection Recess Mounted Dual Sanitary Napkin & Tampon Dispenser: shall hold 30 napkins and 27 tampons of specified sizes.
- Cabinet and door shall be fabricated of alloy 18-8 stainless steel, type 304.
- Cabinet shall be 20 gauge with a 1?? (25mm) wide perimeter return to lay flat against wall.
- Full face door shall be 16 gauge and shall be free of miters, welding or open seams with 15/16?? (24mm) square horizontal return to wall and 3/4 ??(19mm) rounded vertical edges.
- Door shall be attached to the edge of unit with a full length 3/16?? (5mm) dia. stainless steel multi-staked piano hinge and shall be held closed with two (2) rimless tumbler locks keyed alike to other ASI washroom equipment.
- Internal coin-box shall be keyed differently than door locks.
- All exposed surfaces shall have No 4 satin finish and shall be protected during shipment with a PVC film that shall be easily removable after installation.
- Dispensing mechanisms shall be fastener mounted internally to provide ability to change mechanisms for coinage denomination.
- Structural assembly of body and door components shall be of welded construction and have no exposed fasteners or welded seams.
- Weights for each feed track shall be supplied.
- 25? Operation

Installation:
Unit is mounted in wall recess using four (4) No 10 self-tapping screws (by others).
For maximum usability and compliance with ADA Accessibility Guidelines, unit should be installed so that coin slot is between 54?? (1372mm) maximum above finished floor (AFF) and 38?? (965mm) minimum AFF.
Note that coin slot is 6-3/8?? (162mm) above bottom edge of RWO.

Rough Wall Opening (RWO) required is...……….. 16??W x 26??H x 6-1/4??D