ASI 7402-B | ASI Recessed Single Bright Toilet Paper Holder
American Specialty Recessed Single Bright Toilet Paper Holder: shall hold and dispense all standard core roll tissue up to 6'’ diameter (?152) roll and shall be of one piece construction fabricated of stainless steel type 304 alloy 18-8.
- Outer shell shall have two (2) perforated lugs for wet wall anchoring or two (2) dimpled holes for dry wall installation.
- Roller shall be chrome plated high impact resistant ABS plastic and shall be spring-loaded.
- Mounting style shall be wet wall or dry wall as chosen by option and indicated by code suffix.

Installation:
For Wet wall Recessed Mounting:
- Slop grout into rough wall opening.
- Apply grout to back of unit and on perforated lugs and push unit into opening to seat flange flush with wall face.
- Allow unit to set and grout to cure before use.

For Standard Dry Wall Recessed Mounting:
- Use two (2) No 10 stainless steel Philips flat or oval head self tapping or wood screws (by others) of suitable length to penetrate blocking in back of RWO by approximately 1/2" (13).
- Apply a continuous bead of silicone sealant (by others) behind flange.
- Tighten screws to hold flange tight against finished wall face.
- Wipe off excess sealant immediately.

Optional Method for Dry Wall Recessed Mounting:
-Order separate item Model No 39 dry wall clamp.
- Loosely attach clamp to the back of the unit with two (2) stainless steel Philips flat or oval head No 10B (or 10AB or 10BP) self tapping screws (provided by others to suit
wall conditions) through dimpled holes at back of shell.
- Apply a continuous bead of silicone sealant (by others) behind flange.
- Insert into RWO and adjust clamp so that it grips inside wall surface through opening. Secure accessory to clamp and wall by tightening screws.
- Wipe off excess sealant immediately.

For compliance with ADAAccessibility Guidelines: install unit with centerline of roller 19" (483) min AFF to 42" (1067) max AFF and 7" (178) min to 9" (229) max from front of commode to centerline of dispenser.
Rough Wall Opening (RWO) required is 5-1/2" W x 5-1/2" H x 2" D

Option:
Optional finish and mounting style must be specified as either bright or satin and wet or drywall. Specify finish and mounting by adding code suffixes to model number (